Skip to main content

Adding devices to Yggio

Several different type of devices can get added to Yggio. Devices can get added one by one or several at once with batch install. Each device type will require different type of parameters to be entered.

How to connect a LoRa device (Single mode)​

  1. Navigate to "Devices" from the menu bar at the top

  2. Click on "New device" then "Single mode"

  3. In the "Select device type..." drop down, choose LoRaWAN, then hit "Continue"

  4. In the next step you are prompted to select a connector which is a link to a LoRa Network Server such as Chirpstack, TTN, Netmore etc. Select the connector that applies to your device

  5. Once a connector has been chosen, a new drop down is introduced that allows you to select "Activation Type", "OTAA" or "ABP". Choose the type that applies to your device

  6. Fields to enter device keys are now visible as well as other required information. Which fields are required in your case depends on the LoRa Network Server application

  7. If you wish to decode your device's payload, select the mode name that is used for your device. This field can be left empty and changed later on

  8. In the next step you can add additional translators, once you're done, hit "Continue"

  9. The final step "Details" lets you set a name for your device, as well as a description. If you want to add your device to a specific Location (Location Manager), you can do so here. You can also add contextual parameters. When ready, click on "Add device"

  10. The last page "Result" will let you know if your device was added successfully or if problems were encountered

How to connect a LoRa device (Batch mode)​

  1. Navigate to "Devices" from the menu bar at the top

  2. Click on "New device" then "Batch mode"

  3. Upload your csv batch file by dragging and dropping it onto the grey box or click on the grey box and select your file on your computer. If you need information on how to create a batch file, click on the link "What should I put in the file?"

  4. When the file has been uploaded, you will be notified if the file is valid or not. If the file is valid, press "Continue" to proceed

  5. In the next step, the amount of devices to be installed will be displayed, if the information is correct, click on "Start installation"

  6. After the installation has finished, information about the result is shown. In case of errors, download the errors file to troubleshoot. To exit the Batch installer, hit "Done"